![]() The OEM CANoeIL is part of a so called OEM package. Therefore, a special CANoeIL for DBC files is provided for each OEM. ![]() ![]() OEMs use different send models for their networks modelled in DBC files. The general CANoeILNLdefault.dll is used if no Interaction Layer is configured starting CANoe 7.6 The CANoeILNLVector.DLL supports the Vector send model. SN-IND-1-011_InteractionLayer.pdf 2Ĥ 3 Network Types (OEM) CANoe offers two Interaction Layers which can be used with DBC files. The CANoeIL does not accept Network Management Messages. If a frame is marked in the DBC as Network Management Message or the CAN ID is located within the Range of Network Management IDs can be checked in the DBC. Network Management Messages are handled by an appropriate Network Management DLL. 2 CANoeIL and Network Management The CANoeIL sends application frames only. If the signal value is changed or updated, the signal will be routed directly to the specific CANoeIL which is responsible for sending the signal to the bus according to the timing defined in the database. It is possible to map panel controls directly to signals or stimulate the signals from other components like test modules or network nodes. The CANoeIL basically encapsulates the complete send model into a DLL allowing to focus on the essential simulation code in CAPL without the need to take care about sending mechanisms etc. The CANoeIL models the transmission behavior of the remaining bus simulation at runtime using the attributes. The transmission behavior of frames and signals is described based on attributes in the database. The CANoe Interaction Layer (in short CANoeIL) performs mapping of signals to their send frames and controls the sending of these send frames as a function of the send model. ![]() 2 1 Overview This Support Note describes how to set up a CANoe Interaction Layer when using a DBC database. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |